Four requirements for the installation position of the constant temperature and humidity machine

Time:2021/10/25 14:57:00

The constant temperature and humidity machine consists of a cooling system, a heating system, a control system, a humidity system, an air circulation system, and a sensor system. It mainly provides constant temperature and humidity, complex high and low temperature alternation and other test environments and test conditions. So what are the requirements for the installation location of the constant temperature and humidity machine? Next, the editor of the constant temperature and humidity machine will explain this, I hope it can be helpful to everyone, the specific content is as follows:

1. It is very important to maintain a compact space for cleaning and maintenance. Generally, the distance between the constant temperature and humidity device and the wall and other obstacles should be greater than 600mm.

2. In order to prevent freezing of the constant temperature and humidity machine, the equipment should not be exposed to the environment below the dew point of the processing air. In addition, if the equipment is installed outdoors, appropriate protective equipment must be worn. Measures should be taken to prevent the intrusion of snow, rain and frost.

3. The place where the machine is installed must be kept at constant temperature and humidity, avoid places with strong electromagnetic radiation, oily smoke, sand and dust, and be far away from heat sources, corrosive gases, and explosive areas where combustible gases, steam and air are mixed.

4. The installation site of the outdoor unit must have an open space to ensure good heat dissipation of the outdoor condenser. Drain pipes or condensate drain pipes should be arranged around the unit.

The above four points are all about the four requirements for the installation position of the constant temperature and humidity machine. Thank you for your understanding and support!